What Should be Considered When Bevel Cutting on Fiber Laser?

The Short Answer

When looking to add a bevel cutting machine, look to ensure the fiber laser structure is specifically designed for bevel, the laser power is high enough to cut through greater thickness when the head is angled, and that you can live with reduced dynamic motion performance.

Effective Material Thickness

How laser bevel head angle impacts effective material thickness

The first rule of bevel cutting, regardless of laser, plasma, flame or any other cutting process, goes back to high school math and Pythagorean theorem. When cutting at an angle, the beam has to travel through more material than the plate’s measured thickness. For example, a 45° bevel through 1″ material creates an effective cutting thickness of approximately 1.4″. This difference in thickness is enough to require a move from 30 kW up to 60 kW.

The picture below is a good representation of the impact bevel angle has on effective material thickness.

While nitrogen is still preferred, oxygen cutting is much more common in bevel applications. A 30 kW laser, spec’d for 1” material when nitrogen cutting, can handle that 1” thickness at a 45° bevel by switching to oxygen. Of course, this results in slower cutting, heat-affected zone and possible oxide flaking.

Machine Design

Bevel cutting slices up laser slatsA flat-stock cutting bevel head can be used on enclosed flat lasers or open table flat lasers. At Fairmont, we urge our customers to consider open-table layouts when bevel cutting rather than enclosed table layouts for two reasons. More details about enclosed and open-table flat lasers can be found here.

First, when bevel cutting inward around the perimeter of a sheet, the laser head must travel beyond the edge of the material. And when bevel cutting outward the beam extends beyond the cutting area toward machine structure. On a Fairmont laser, this requires 1.5′ of additional table clearance in all directions to cut a full 45° bevel.  On enclosed machines this extra cutting head travel distance forces the pallet changer and enclosure to be larger, adding significant cost. On open table machines, adding bridge and base travel is not nearly as costly. 

Bevel cutting also slices up the support slats. While this obviously occurs on both open-table and enclosed machines, the impact is very different. On open-table machines, a broken slat is replaced with a new slat. On enclosed machines with pallet changers, the broken slat hangs down – often invisible to the operator under the cut sheet. When the pallets swap, the hanging slat collides with the other table. The resulting tangled mess of metal is not pretty.

Increased Cycle Times vs Straight Cutting

Due to the extra degrees of freedom, bevel cutting heads are heavier than straight heads. More weight has minimal impact on top speed, but it reduces acceleration – therefore increasing cycle times. Since this extra cutting head weight is carried regardless of whether the machine is currently bevel cutting, these longer cycle times exist on both bevel and non-bevel parts.

But it is important to note that this this reduction in acceleration is most noticeable on thin material – not thick. On thick material, power is limiting cut speed, rather than machine dynamics (learn more here). Since bevel cutting machines are typically designed for thick material, the cycle time impact on thin parts is far less of a concern.

Author: Alex Burnham, Senior Product Manager, Fairmont Machinery
Technical Review: Chip Burnham, Owner & CEO, Fairmont Machinery
Last updated: September 2026